One of the most vital elements of your kegerator dispense system is CO2, co2. To make sure a perfect pour every time, your Carbon dioxide tank has to be governed, enhanced, and effectively set up. Whether it is the initial kegerator or you should make adjustments to your present kegerator create, we now have you engrossed in what you should know to achieve the perfect put.

Co2 Pressure Regulator

CO2 can be dangerous! Please use caution and constantly adopt these measures:

* Constantly link the Carbon dioxide gas tube to the decreasing device or regulator. Malfunction to accomplish this could result in an explosion with possible death or injuries once the tube device is opened.

* Never connect the gas tube directly to the keg.

* Constantly safe the gas tube inside the “vertical” position.

* Remember to keep gasoline cylinders from heat.

* Never drop or throw a CO2 gas cylinder.

* Always ventilate after CO2 leakage.

* Always check the D.O.T. (Division of Transport) test date located on the neck from the tube prior to installation. If over 5 (5) many years, tend not to use and return the gas tube for the gasoline provider.

* Never connect a product container unless there are 2 (2) safety systems in the pressure system.

* One at or around the CO2 regulator (the regulator provided needs to be comprehensive of the a security system).

* One at or in the product container coupler or in the pressure gas line (the keg coupler should be comprehensive of these a security mechanism).

* If it becomes hard to breathe along with your head actually starts to ache, irregular concentrations of co2 may be present in the area. Near the key device around the CO2 tube and then leave the room instantly.

* Gasoline cylinders ought to be stored in the coolest part of the establishment, ideally at 70 degrees, and safely fastened inside the upright place ahead of the primary regulator is connected to the tube.


A regulator is an important a part of a kegerator distribute system, assisting monitor your Carbon dioxide pressure. You can find single gauge regulators or dual measure regulators, which connect to air line and study the pressure of your tank.

With a single measure regulator, the show displays only your Carbon dioxide pressure. Having a dual gauge regulator, you want to glance at the gauge that shows a variety of -60 PSI (pounds for each square inch). To read through your oeztin in the regulator, you will notice an arrow point to your current Carbon dioxide pressure in PSI.


Based on the beer you are helping your Carbon dioxide tank pressure will vary. Most American breweries suggest a pressure between 10-14 PSI. Should you aren’t advised on the pressure by the dark beer producer or maybe it’s your very own homebrew, it is recommended to start dispensing at 10 PSI and adjust appropriately up until you reach the perfect pour.

Co2 Pressure Regulator – Premium Kitchen Fittings Wholesale Supplier..